70-740 Dumps 70-740 Exam Questions 70-740 New Questions 70-740 PDF 70-740 VCE Microsoft

[2017 New] Latest 70-740 Dumps PDF Free Download In Lead2pass (1-15)

2017 April Microsoft Official New Released 70-740 Q&As in Lead2pass.com!

100% Free Download! 100% Pass Guaranteed!

There are many companies that provide 70-740 braindumps but those are not accurate and latest ones. Preparation with Lead2pass 70-740 new questions is a best way to pass this certification exam in easy way.

Following questions and answers are all new published by Microsoft Official Exam Center: http://www.lead2pass.com/70-740.html

QUESTION 1
You have a server named Server 1 that runs Windows Server 2016 and has the Hyper-V server role installed.
On Server1, you plan to create a virtual machine named VM1.
You need to ensure that you can start VM1 from the network.
What are two possible ways to achieve the goal? Each correct answer presents a complete solution.

A.    Create a generation 2 virtual machine.
B.    Create a generation 1 virtual machine and run the Enable-NetAdapterPackageDirect cmdlet.
C.    Create a generation 1 virtual machine that has a legacy network adapter.
D.    Create a generation 1 virtual machine and configure a single root I/O virtualization (SRV-IO) interface for the network adapter.

Answer: AC
Explanation:
To boot a virtual machine from the network, it must be generation 2 VM, or Generation 1 VM connected to legacy network adapter.

QUESTION 2
Note: This question is part of a series of questions that use the same similar answer choices. An answer choice may be correct for more than one question in the series. Each question is independent of the other questions in this series. Information and details provided in a question apply only to that question.

You have a Hyper-V host named Server1 that runs Windows Server 2016.
Server1 has a dynamically expanding virtual hard disk (VHD) file that is 900 GB The VHD contains 400 GB of free space.
You need to reduce the amount of disk space used by the VHD.
What should you run?

A.    the Mount-VHD cmdlet
B.    the Diskpart command
C.    the Set-VHD cmdlet
D.    the Set-VM cmdlet
E.    the Set-VMHost cmdlet
F.    the Set-VMProcessor cmdlet
G.    the Install-WindowsFeature cmdlet
H.    the Optimize-VHD cmdlet

Answer: H

QUESTION 3
Note: This question is part of a series of questions that present the same scenario. Each question in the series contains a unique solution that might meet the stated goals. Some question sets might have more than one correct solution, white others might not have a correct solution.

Your network contains an Active Directory forest.
You install Windows Server 2016 on 10 virtual machines.
You need to deploy the Web Server (IIS) server role identically to the virtual machines.
Solution: You use Windows PowefShell Desired State Configuration (DSC) to create a default configuration and then you apply the configuration the virtual machines.
Does this meet the goal?

A.    Yes
B.    No

Answer: A

QUESTION 4
You have a Nano Server named Nano1.
Which cmdlet should you use to identify whether the DNS Server role is installed on Nano1?

A.    Find-NanoServerPackage
B.    Get-Package
C.    Find-Package
D.    Get-WindowsOptionalFeature

Answer: B

QUESTION 5
In this section, you’ll see one or more sets of questions with the same scenario and problem. Each question presents a unique solution to the problem, and you must determine whether the solution meets the stated goals. Any of the solutions might solve the problem. It is also possible that none of the solutions solve the problem.
Once you answer a question in this section, you will NOT be able to return to it. As a result. these questions will not appear in the review screen
Note: This question is part of a series of questions that present the same scenario. Each question in the series contains a unique solution. Determine whether the solution meets the stated goals.

Your network contains an Active Directory forest named contoso.com.
The forest contains a member server named Server1 that runs Windows Server 2016.
All domain controllers run Windows Server 2012 R2.
Contoso com has the following configuration:

 

You plan to deploy an Active Directory Federation Services (AD FS) farm on Server1 and to configure device registration.
You need to configure Active Directory to support the planned deployment.
Solution: You raise the domain functional level to Windows Server 2012 R2.
Does this meet the goal?

A.    Yes
B.    No

Answer: B

QUESTION 6
You are configuring a Windows Server 2016 failover cluster in a workgroup.
Before installing one of the nodes, you run the ipconfig /all command and receive the following output:

 

You need lo ensure that Server 1 can be added as a node in the cluster. What should you do1?

A.    Assign a static IP address
B.    Change the Node Type to Broadcast
C.    Configure a DNS suffix
D.    Enable NetBIOS over TCP/IP

Answer: C

QUESTION 7
Note: This question is part of a series of questions that present the same scenario. Each question in the series contains a unique solution that might meet the stated goals. Some question sets might have more than one correct solution, white others might not have a correct solution. After you answer a question in this section, you will NOT be able to return to it. As a result, these questions will not appear in the review screen.

You are a server administrator at a company named Contoso, Ltd.
Contoso has a Windows Server 2016 Hyper-V environment configured as shown in the following table.

 

All of the virtual switches are of the external type.
You need to ensure that you can move virtual machines between the hosts without causing the virtual machines to disconnect from the network.
Solution: You implement a Hyper-V Replica between Host2 and Host4.
Does this meet the goal?

A.    Yes
B.    No

Answer: B
Explanation:
To meet the goal, you must use Live Migration. HyperV replica will cause the host to disconnect from the network.
To use Live Migration, hosts must be connected to the same VSwitch and have the same brand of processor.

QUESTION 8
Note: This question is part of a series of questions that present the same scenario. Each question in the series contains a unique solution that might meet the stated goals. Some question sets might have more than one correct solution, while others might not have a correct solution. After you answer a question in this section, you will NOT be able to return to it. As a result, these questions will not appear in the review screen.

You have two servers that run Windows Server 2016.
You plan to create a Network load Balancing (NLB) cluster that will contain both servers.
You need to configure the network cards on the servers for the planned NLB configuration.
Solution: You configure the network cards to be on the same subnet and lo have dynamic IP addresses.
You configure the cluster to use multicast.
Does this meet the goal?

A.    Yes
B.    No

Answer: B
Explanation:
To use Network Load Balancing, dynamic IP(DHCP) is not supported. IP must be statically assigned.
All hosts must be configured to use unicast or multicast, but not both. All hosts must also be on the same subnet.

QUESTION 9
You have a server named Server1 that runs Windows Server 2016.
You need to configure Server1 as a multitenant RAS Gateway.
What should you install on Server1?

A.    the Network Policy and Access Services server role
B.    the Remote Access server rote
C.    the Data Center Bridging feature
D.    the Network Controller server role

Answer: B

QUESTION 10
In this section, you’ll see one or more sets of questions with the same scenario and problem. Each question presents a unique solution to the problem, and you must determine whether the solution meets the stated goals. Any of the solutions might solve the problem. It is also possible that none of the solutions solve the problem.
Once you answer a question in this section, you will NOT be able to return to it. As a result. these questions will not appear in the review screen
Note: This question is part of a series of questions that present the same scenario. Each question in the series contains a unique solution. Determine whether the solution meets the stated goals.

Your network contains an Active Directory forest named contoso.com.
The forest contains a member server named Server1 that runs Windows Server 2016.
All domain controllers run Windows Server 2012 R2.
Contoso com has the following configuration:

 

You plan to deploy an Active Directory Federation Services (AD FS) farm on Server1 and to configure device registration.
You need to configure Active Directory to support the planned deployment.
Solution: You raise the forest functional level to Windows Server 2012 R2.
Does this meet the goal?

A.    Yes
B.    No

Answer: B
Explanation:
The Forest Functional Level cannot be raised higher than the Domain Functional Level.

QUESTION 11
Note: This question is part of a series of questions that present the same scenario. Each question in the series contains a unique solution that might meet the stated goals. Some question sets might have more than one correct solution, while others might not have a correct solution. After you answer a question in this section, you will NOT be able to return to it. As a result, these questions will not appear in the review screen.
You are a server administrator at a company named Contoso, Ltd. Contoso has a Windows Server 2016 Hyper-V environment configured as shown in the following table.

 

All of the virtual switches are of the external type.
You need to ensure that you can move virtual machines between the hosts without causing the virtual machines to disconnect from the network.
Solution: You implement live migration by using Host3 and Host4.
Does this meet the goal?

A.    Yes
B.    No

Answer: B
Explanation:
Virtual switches must match for Live Migration.

QUESTION 12
You need to ensure that VM1 and VM2 can communicate with each other only.
The solution must prevent VM1 and VM2 from communicating with Server1.
Which cmdlet should you use?

A.    Set-NetNeighbor
B.    Remove-VMSwitchTeamMember
C.    Set-VMSwitch
D.    Enable-VMSwitchExtension

Answer: C

QUESTION 13
You have a Windows Server 2016 Hyper-V failover cluster that contains two nodes named Node1 and Node2.
On Node1, you create a virtual machine named VM01 by using Hyper-V Manage.
You need to configure VM01 to move to Node2 automatically if Node1 becomes unavailable.
What should you do?

A.    From Failover Cluster manager, run the configure Role actions.
B.    From Hyper-V Manager, click VM01 and click Enable Replication.
C.    From Hyper-V Manager Click Node 1 and the modify the hyper-V settings.
D.    From Windows Powershell, run the Enable-VMReplication cmdlet.

Answer: A
Explanation:
Automatic failover in a cluster is configured from Failover Cluser Manager.

QUESTION 14
You have a server named Served that runs Windows Server 2016. Server1 will be used as a VPN server.
You need to configure Server1 to support VPN Reconnect.
Which VPN protocol should you use?

A.    PPTP
B.    L2TP
C.    SSTP
D.    lKEv2

Answer: D

QUESTION 15
Note: This question is part of a series of questions that present the same scenario. Each question in the series contains a unique solution that might meet the stated goals. Some question sets might have more than one correct solution, white others might not have a correct solution.

You have a server named Server1 that runs Windows Server 2016. Server1 hosts a line-of- business application named App1.
App1 has a memory leak that occasionally causes the application to consume an excessive amount of memory.
You need to log an event in the Application event log whenever App1 consume more than 4 GB of memory.
Solution: You create a system configuration information data collector.
Does this meet the goal?

A.    Yes
B.    No

Answer: B

We give you the proper and complete training with free 70-740 Lead2pass updates. Our braindumps will defiantly make you perfect to that level you can easily pass the exam in first attempt.

70-740 new questions on Google Drive: https://drive.google.com/open?id=0B3Syig5i8gpDTzFiNkZZMGowWWs

2017 Microsoft 70-740 exam dumps (All 113 Q&As) from Lead2pass:

http://www.lead2pass.com/70-740.html [100% Exam Pass Guaranteed!!!]